Selection of installation equipment
As shown in Figure (1)
1
Power level 1 2 3 4 5 6 7 8 9
Default working
time(hour)
8 8 8 4 4 4 2 2 2
56 cm
49cm
The default working timers for various power levels are shown in the table below:
ADVICE FOR THE INSTALLER
IMPORTANT
Appliance installation and maintenance must only be carried out by QUALIFIED
TECHNICIANS and in compliance with the local safety standards. Failure to
observe this rule will invalidate the warranty.
Drill holes on the table surface according to the sizes shown in the drawing.
A minimum of 50 mm space shall be preserved around the hole.
Be sure the thickness of the table surface is at least 30mm. Select heat-resistant
table material to avoid deformation caused by the heat radiation from the Hob
5
