HERO H100B
6
- 2 - INSTALLATION
2.1 MOUNTING
The HERO H100B includes a mounting bracket designed for overhead installation; it may be installed at
floor level or suspended overhead. If the unit is to be mounted using the bracket, it is important that the
bubbles do not shoot directly at anyone’s face. Whatever installation method you choose, do not allow the
unit to have more than a 25 degree angle of inclination.
Important:
When carrying out any installation, always comply scrupulously with all the regulations (particularly re-
garding safety) currently in force in the country in which the fixture’s being used.
- 3 - FUNCTIONS AND SETTINGS
3.1 BASIC
1. Remove all packing materials from the bubble machine.
2. Place bubble machine on a flat surface.
3. Loosen the side screws and lift the housing upwards. You will see a liquid tank.
4. Pour bubble liquid into the liquid tank. Be careful not to exceed the maximum fluid level. DO NOT
OVERFILL.
5. It is recommended to use Prolights Bubble Liquid for best performance.
6. When the container is 3/4 full, lower the housing and tighten the screws.
Important:
•
Always monitor tank fluid level as you are operating.
•
Never drink bubble liquid. If it is ingested, call a doctor immediately. If the bubble liquid comes in con-
tact with skin or eyes, rinse thoroughly with water.
•
Always replace the caps on the liquid container immediately after filling to avoid contamination.
3.2 ADD PROLIGHTS LIQUID
NOTE - Ensure your bubble machine is unplugged from the mains electrical supply before attempting to
open the housing.
To help avoid accidental exposure to dangerous live AC mains voltage, two safety screws are fitted that
require a screw driver to remove. Once these are removed, the finger screws can be undone by hand (see
above).
Fig.2
Safety Screw
Finger Screw
