CYBER 128
10
- 4 - PROGRAMMING
4.1 ENTERING PROGRAM MODE
A program (bank) is a sequence of different scenes (or steps) that will be called up one after another. In the
CYBER128, 6 programs can be created with up to 999 steps each.
1. Press and hold the
[PROGRAM]
button for 3 seconds (fig.4).
5. To program another FIXTURE press the
[FIXTURES]
button you have just finished programming then
select another
[FIXTURES]
button to program.
6. Repeat steps 2 ~ 4 until you have your look.
7. Move the
[SPEED]
and
[FADE]
sliders to adjust the speed and fade time of the scene.
8. Tap
[MUSIC/ADD]
button to store.
9. All FIXTURES LEDs will flash, indicating a successful save of the step to the memory.
10. The display will automatically go on to the next step. Use the
[STEP UP]
and
[STEP DOWN]
buttons to
navigate through the existing steps in the Chase.
11. Repeat steps 2 ~ 8 to record more scenes.
12. To exit program mode, hold the
[PROGRAM]
button for 3 seconds. The controller will default to a
BLACKOUT
when exiting the programmer.
NOTE - Deselect
BLACKOUT
if LED is lit.
A
FIXTURES
button represents one lighting fixture.
You can access channels 9~16 by pressing the Page Select button. This is necessary for fixtures that use
more than 8 channels of control. When switching pages it will be necessary to move previously moved
faders up then down to activate.
Pressing the same
FIXTURES
button again will hold the parameters changed for that fixture in the program
scene.
There are 999 scenes available for every chase.
Fig.4
2. Select a
[FIXTURES]
to program.
3. Select a
[CHASE]
to store the program to (1~6).
4. Compose a look by moving the
[FADERS]
. (Changes in fixture attribute such as colors and gobos)
Press
[PAGE SELECT]
to access Channels 9~16 on the faders (fig.5).
Fig.5 - Display
example DMX
value “255”
Содержание CUBER128
