Prolights Tribe PHYRO1000D, Руководство пользователя

Страница: 21 / 28

7 PHYRO1000D
2.3 OPERATION
1. Add fluid carefully to the liquid tank. Do not overfill the tank.
2. Plug power cord into a grounded electrical outlet. Turn the power switch to “ON” on the back of the
machine. The unit will start to warm-up the machine. Wait a few minutes for heating element to heat
up. During this time the machine cannot generate any fog. When the warm-up process is complete the
green light will stay ON.
3. Please now refer below of instructions of Remote Controller for setting for the remote controller com-
mand.
Important:
• Always monitor tank fluid level as you are fogging.
• Never drink Fog liquid. If it is ingested, call a doctor immediately. If fog liquid comes in contact with skin
or eyes, rinse thoroughly with water.
• Always replace the caps on the fog liquid container immediately after filling to avoid contamination.
NOTE - If you experience low output, pump noise or no output at all, unplug immediately. Check fluid
level, the external fuse, and power from the wall. If all of the above appears to be O.K., plug the unit again.
If fog does not come out after holding the remote button down for 30 seconds, check the hose attached
to the tank to make sure there is fluid going through the hose.
If you are unable to determine the cause of the problem, do not simply continue pushing the remote but-
ton, as this may damage the unit. Return the machine to your dealer.
2.4 REMOTE CONTROLLER OPERATION
WARNING : before removing or replacing the remote control unit disconnect the power cord.
• The DMX INPUT must not be connected.
• Via the DMX OUTPUT, it is possible connect further PHYRO1000D units.
FUNCTION DIRECTION
INTERVAL
Setting of interval time, effective when starting the
timer function
DURATION
Setting of duration time, effective when starting the
timer function
OUTPUT
Pushing this button, the unit will issue the desided
volume (0% - 100%)
TIMER ON/OFF
Puffing timely according to the adjusted volume, du-
ration, interval, on the display
CONTINUOUS
Press the button to activate continuous emission of
fog
MANUAL Pushing this button, the unit will issue smoke
YELLOW LED
Lights up when the timer function is active
RED LED
Lights up when the remote controller is connected
to the haze machine
GREEN LED Lights up when the haze machine is ready to for use
NOTE - The length of the cable is 4,5 m
Fig.2