JOYSTICK/CHANNEL SELECTION
l
Set-up Joystick
1)
Press and hold the “Program” button until LED is lit.
2)
Press and hold the “Mode” and “Fine” buttons at the same time, the assign
LED should light. If the reverse LED lights, press “Fine” and “Mode”
again to enter assign mode.
3)
Use the bank Up and Down keys to select the axis you wish to assign (Pan
or Tilt).
4)
Use the “Tap/Display” button to select 16 or 8 channel mode.
5)
Press the button corresponding to the scanner you wish to assign.
6)
While holding the mode button press the scene number corresponding to
the slider which controls the movement. (Example: If pan is controlled by
slider number 4, press and hold the “Mode” button while tapping scene
button 4#).
7)
When finished press the “Mode” and “Fine” button at the same time again
to exit Assign mode.
l
Reverse Joystick Movement/DMX Channel
1)
Enable Programming Mode.
2)
Press the Fine and Mode buttons to enter assign mode, then press Fine and
Mode buttons again to enter reverse mode. The reverse LED lights up
indicating reverse mode is active.
3)
Use Bank Up/Down button to change between the Pan and Tilt, the
corresponding LED lights indicating this selection.
4)
Press the Tap/Display button to change between 8 CHANNEL and 16
CHANNEL mode.
5)
Press the scanner buttonto select the scanner.
6)
While holding the mode button, press the corresponding scene button the
channel you wish to reverse. (For Example: If you are reversing the on one
scanner, once you verify that you are in reverse mode, and the Tilt LED is
lit, check to see which slider the Tilt control is on. Hold the mode button
and press the scene button that is same as the slider number for tilt. (Slider
5/Scene 5).
7)
Continue steps 3-7 as needed. You may reverse a maximum of 48 channels
for 12 scanners.
l
Delete a scanner of DMX Channels
1)
Activate Assign or reverse mode.
2)
Tap the scanner button to select the scanner you wish to delete.
3)
Press the mode and Auto/Del buttons at the same time. All LEDs will flash
three time indicating the requested operation has been performed.
l
Clear All DMX Channels
1)
Turn the power to the unit off.
2)
Press the Mode and Auto/Del buttons at the same time.
3)
While holding the two buttons, turn the power back on to the unit. All
LEDs will flash briefly indicating the requested operation has been
performed.
l
Display DMX Channel
1)
Press the Fine and Mode buttons at the same time, putting the controller
into assign mode.
2)
Press the Fine and Mode buttons again, lighting the reverse LED.
3)
Press the scanner button that is set at the desired Pan and Tilt and the LCD
will display the DMX values for Pan and Tilt.
FADE TIME
l
Fade Time/Assign Fade Time
1)
With the power off, press the mode and Tap/Display buttons at the same
time.
2)
Apply the power again, tap the Tap/Display button to change between Fade
Time and Assign Fade Time, the LCD reads
A
L
L
O
N
L
Y
F
D
F
D
C
H
X
/
Y
O
R
T
I
M
E
T
I
M
E
3)
Press the Mode and Tap/Display buttons at the same time to store your
setting into memory. If you do not wish to save your setting, press the
blackout key to exit this operation.
PLAYBACK
l
Running Scenes
Содержание TRANSCENSION DMX OPERATOR 2
Страница 9: ......
