Prolight TRANSCENSION DMX OPERATOR 2, Руководство пользователя

Страница: 3 / 9

3. DMX IN –
This connector accepts your DMX input signals .
4. Fog Machine Connector –
This connector is used to plug in the Fog Machine .
5. DC Input –
DC9-12V, 500mA min..
6. Power Switch –
This switch turns On/Off the power .
7. AUDIO IN –
0.1V~1Vp-p .
V
．
OPERATION
l General:
The unit allows you to program 12 scanners with 16 DMX channels each, 30
banks of 8 programmable scenes, 6 chases of 240 scenes using 8 channel sliders,
a joystick, and other buttons. With the ease of the joystick, you can easily and
more accurately control the movement of a fixture. To further your ability to
dazzle the audience, this unit allows you to assign and revement DMX channels.
In addition, two units can set up communication so that they can send or receive
a complete file dump.
l Display Information:
The LCD Display contains a maximum of 2 lines, each of 8 characters. Below
are the definitions.
LCD Display Message
SN1 Scene 1
BK1 Bank 1
CHASE1 Chase 1 is activated
STEP 009 The ninth step of a chase
DATA 184 DMX Value (000-255)
SP: 1M54s The current speed is 1 minute 54 seconds
TP: 4.25s The time of the last two taps is 4.25 seconds
ASS 04 05 Assign DMX channels 4 and 5
RES 10 13 Reverse DMX channels 10 and 13
SET UP
l Unit Setup
The unit is preset to allocate 16 channels per fixture. In order to assign your
fixtures to the scanner buttons located on the left side of the unit you will need
to space your fixtures 16 DMX channels apart.
Use the Following chart for DMX Addressing
Fixture # Digital # Dip Switch Setting
1 1 1 “On”
2 17 1 and 5 “On”
3 33 1 and 6 “On”
4 49 1,5 and 6 “On”
5 65 1 and 7 “On”
6 81 1,5 and 7 “On”
7 97 1,6 and 7 “On”
8 113 1,5,6 and 7 “On”
9 129 1 and 8 “On”
10 145 1,5 and 8 “On”
11 161 1,6 and 8 “On”
12 177 1,5,6 and 8 “On”
l Enabling the program mode
To enable program mode, hold the program button for seconds until LED is lit.
l Set-up Joystick
1) Press and hold the “Program” button until LED is lit.
2) Press and hold the “Mode” and “Fine” button at the same time, the assign
LED should light. If the reverse LED lights, press “Fine” and “Mode”
again to enter assign mode .
3) Use the bank UP and DOWN keys to select the axis you wish to assign
(Pan or TILT).
4) Use the “Tap/Display” button to select 16 or 8 channel mode.
5) Press the button corresponding to the scanner you wish to assign.
6) While holding the mode button press the scene number corresponding to
the slider which controls the movement. (Example: If pan is controlled by
slider number 4, press and hold the “Mode” button while tapping scene
button 4#).