2)
Press the desired Scene button to select the scene you wish to delete.
3)
Press and hold down the Auto/Del button. While holding the button, tap the
scene button that corresponds with the scene you wish to delete.
4)
When the programmed scene is delete, all DMX channel values will be set
to 0.
l
Deleting All Scenes
1)
With the power off to the unit, press and hold down the Program and Bank
Down buttons at the same time.
2)
Turn the unit back on, and all scenes should be cleared.
l
Copy A Bank of Scenes
1)
Enable Programming Mode.
2)
Tap the Bank Up/Down button until you reach the bank you wish to copy.
3)
Tap the Rec button.
4)
Tap the Bank Up/Down button to select the bank you wish to copy to.
5)
Tap the Music/Bank Copy button, all LEDs will briefly flash three times
indicating the function has been completed.
6)
Press the program button for three seconds to exit programming mode.
CHASES
l
Programming a Chase
Note: You must have already programmed scenes in order to program a chase,
this function allows you to cycle through up to 240 scenes in a preselected order.
It is recommended before programming chases for the first time, you delete all
chases in the controller. See Delete All Chases for instructions on how to do so.
1)
Enable Programming Mode.
2)
Tap the Chase button to select the chase you wish to program.
3)
Select a desired scene from the bank that has scenes stored inside it.
4)
Tap the Rec button.
5)
Repeat steps 3-4 until all desired scenes scenes have been entered.
l
Inserting a bank of scenes into a chase
1)
Enable Programming Mode.
2)
Select the chase you wish to program.
3)
Use the Bank Up/Down key to select the bank of scenes you wish to copy.
4)
Tap the Music/Bank Copy button.
5)
Tap the Rec copy button, all LEDs will flash three times indicating that the
requested operation has been performed.
l
Add A Step
1)
Enable Programming Mode.
2)
Press the corresponding button to the chase you wish to add a step to.
3)
Press the Tap/Display button, the LCD will show the current step.
4)
Press the Bank Up/Down button and scroll to the step you wish to insert the
step after.
5)
Press the Rec button, the segment display will read the step one step higher
than before.
6)
Tap the Tap/Display buttonagain. The LCD shows the current chase, scene,
and bank. Create a desired scene and record it as a new step or select a
previously programmed scene to add to the chase.
7)
Once you have selected the scene you wish to add, press the MIDI/Rec
button again. All LEDs will flash three time indicating the new step has
been inserted into the chase.
l
Deleting A Step
1)
Enable Programming Mode.
2)
Select the chase that contains the step you wish to delete.
3)
Press the Tap/Display button, the LCD shows the current step.
4)
Press the Bank Up/Down button and scroll to the step you wish to delect.
5)
Press the Auto/Del button to delete the step. All LEDs will flash three times
indicating the requested operation has been performed.
l
Delete A Chase
1)
Press the button corresponding to the chase you wish to delete.
2)
Press and hold down the Auto/Del button while holding down the chase
button. All LEDs will flash three time indicating that the requested
operation has been performed.
l
Delete A Chase
1)
With the power off, press and hold down the Auto/Del and Bank Down
buttons at the same time.
2)
Reapply the power, and all chases should be cleared.
Содержание TRANSCENSION DMX OPERATOR 2
Страница 9: ......
