7
4. Orient the Upright Cover (5) and the Upright (3)
as shown. While another person holds the
Upright Cover and the Upright near the Frame
(1), insert the Wire Harness (73) upward
through the Upright Cover and the Upright.
Tip:
Use an elastic band or a piece of tape to pre-
vent the Wire Harness from falling into the
Upright.
Tip: Avoid pinching the Wire Harness (73)
during this step.
Insert the Upright (3) through
the Upright Cover (5) into the Frame (1). Then,
slide the Upright Cover upward and attach the
Upright to the Frame with three M8 x 16mm
Button Screws (53).
Tip: Start all the Button
Screws before tightening them.
4
3
1
5
73
53
53
53
5
5. The Console (4) requires four 1.5V “D” batteries
(not included); alkaline batteries are recom-
mended.
IMPORTANT: If the elliptical exercis-
er has been exposed to cold temperatures,
allow it to warm to room temperature before
inserting batteries into the Console. If you
do not do this, the console displays or other
electronic components may become dam-
aged.
Remove the two screws from the back of
the console, and remove the battery cover.
Insert four batteries into the Console. Orient the
batteries as shown by the markings inside the
battery compartment. Then, reattach the battery
cover.
Note: The Console (4) can be operated with an
optional power supply instead of batteries.
To
purchase a power supply, call the telephone
number on the front cover of this manual.
Plug one end of the power supply into the jack
on the Console. Plug the other end of the
power supply into an appropriate outlet that is
properly installed in accordance with all local
codes and ordinances.
4
Batteries
Batteries
Battery
Cover
Screws
Avoid pinching the
Wire Harness (73)
during this step
