ProForm ERGO STRIDER 3.0, Руководство пользователя

Страница: 11 / 24

11
13. Make sure that all parts of the elliptical exerciser are properly tightened. Note: Some hardware may be
left over after assembly is completed. To protect the floor or carpet from damage, place a mat under the
elliptical exerciser.
12. Apply a small amount of grease to the barrel of
an M6 x 71.5mm Shoulder Bolt (31).
Have another person hold the right Pedal Arm
(14) inside the bracket on the right Upper Body
Leg (6).
Attach the right Pedal Arm (14) to the right
Upper Body Leg (6) with the M6 x 71.5mm
Shoulder Bolt (31), an M6 x 16mm x 1.5mm
Washer (36), and an M6 Locknut (77).
Identify the Right Outer Leg Cover (20) and the
Right Inner Leg Cover (21), which are marked
with “Right” stickers, and orient them as shown.
Attach the Right Outer Leg Cover (20) and the
Right Inner Leg Cover (21) around the right
Upper Body Leg (6) with three M4 x 12mm
Screws (35).
Repeat this step for the left side of the ellip-
tical exerciser.
12
11. Identify an Inner Pivot Cover (19). Orient the
Inner Pivot Cover and the right Upper Body Leg
(6) as shown.
Slide the Inner Pivot Cover (19) and the right
Upper Body Leg (6) onto the right axle on the
Upright (2).
Attach the right Upper Body Leg (6) to the axle
with an M6 x 16mm Patch Screw (80) and an
M6 x 25mm x 1.5mm Washer (33).
Identify and orient an Outer Pivot Cover (16) as
shown. Then, slide the Outer Pivot Cover onto
the outer side of the right Upper Body Leg (6).
Attach the Inner and Outer Pivot Covers (19,
16) with two M4 x 16mm Screws (84).
Repeat this step for the left side of the ellip-
tical exerciser.
20
36
77
35
31
14
21
6
11
16
19
6
84
2
33
80
Grease