23
MAINTENANCE AND TROUBLESHOOTING
Inspect and tighten all parts of the exercise cycle reg-
ularly. Replace any worn parts immediately.
To clean the exercise cycle, use a damp cloth and a
small amount of mild soap. Important: To avoid
damage to the console, keep liquids away from
the console and keep the console out of direct
sunlight.
BATTERY REPLACEMENT
If the console display becomes dim, the batteries
should be replaced; most console problems are the
result of low batteries. See assembly step 4 on page
5 for instructions.
PULSE SENSOR TROUBLESHOOTING
If the chest pulse sensor does not function properly,
refer to CHEST PULSE SENSOR TROUBLE-
SHOOTING on page 8.
If the handgrip pulse sensor does not function proper-
ly, refer to step 5 on page 13.
HOW TO LEVEL THE EXERCISE CYCLE
After the exer-
cise cycle has
been moved to
the location
where it will be
used, make sure
that both ends of
front stabiliser
are touching the
floor. If the exer-
cise cycle rocks
slightly during
use, turn one or
both of the levelling feet under the front stabiliser until
the rocking motion is eliminated.
HOW TO ADJUST THE REED SWITCH
If the console does not display correct feedback, the
reed switch should be adjusted. To adjust the reed
switch, the Left Side Shield (17) must be removed.
Remove the seven Screws (52) from the Right Side
Shield (18). Next, remove the Screw (71) from the
right side of the Side Shield Cover (19).
Using an adjustable wrench, turn the Left Pedal (24)
clockwise and remove it. Next, remove the two
Screws (66) from the Left Side Shield (17). Remove
the Screw (71) from the left side of the Side Shield
Cover (19) and lift it off. Gently remove the Left Side
Shield.
52
71
18
19
52
66
71
17
24
19
Levelling
Foot
