Profitech Diamant BS 250, Инструкция по эксплуатации

Страница: 13 / 28

13
Operation instructions
The floor grinder is designed to be used either wet or dry. If the floor is being dround dry, ensure, a
suitable industrial vacuum is connected and that the operator is wearing suitable breathing respiratory
equipment. Contact your local working place health authority to ensure that their requirements regar-
ding respiratory equipment are being met.
Starting the grinder
• Check the grinding plate being used is suitable for the material AND THAT TEY ARE CORRECTLY
BALANCED.
• Check that the grinding plates being used are in good order and properly attached,with all counter-
sunk bolts firmly in place. Check this occasionally during use, as they can work loose during operati-
on-
• Check that the grinding plate is adjusted so that it sits level on the ground.
• Check that all nuts and bolts on the folding handle latch are tight and firm.
• Raise the grinding plates from the floor.
• Start the motor by pressing the black switch on the starter box.
• Lower the grindign plate and commence grinding.
Stopping the grinder
• Press the red stop button on the starter box.
Note
• By turning and pushing the handles, you can fix vertical grinding position (photo 1)
• You can adjust the axle‘s width for your need (photo 2).
Other instructions for working:
1. Wear clothes suitable for the job and for the working place including safety shoes, a hat, hearing
protection, safety googles and dust respirator suitable for dust.
2. Be sure all equipment is tested and tagged prior to use on any job.
3. Inspect the entire area before grinding and removea any bolts or concrete nails (etc.) from the
ground, that could damage the diamond tools or the machine and cause a hazardous situstion.
4. Ensure there are no obstacles or existing structures that could cause a hazard to the operator. If so,
take necessary action to eliminate the hazard.