6
For the ProfiShark 10G to be ready to analyze traffic, take the following steps (any order):
◉
Launch the ProfiShark Manager.
◉
Launch the software network analyzer.
◉
Connect the network to be monitored to the ProfiShark 10G using copper or fiber
optic SFP/SFP+ and cables.
◉
Connect the ProfiShark 10G to the computer, using the supplied USB 3.0 cable.
◉
If copper SFP/SFP+ modules are being used,
connect either the supplied USB
to DC power cable or a compatible 5V/1.5A power supply to the ProfiShark 10G, to
ensure the required amperage is being supplied to the unit. In the absence of an
additional power connection, the ProfiShark 10G is powered through the USB 3.0
port alone and can only sustain fiber optic SFP/SFP+ modules.
▶
NOTE:
Connecting to a USB port of lower specification than USB 3.0 may result in
insufficient powering, as well as data drops due to bandwidth limitations.
▶
NOTE:
Connecting the ProfiShark 10G to a different USB port than the one used
during the installation requires a reboot of the computer (with the ProfiShark
connected) for automatic driver installation for this USB port, and proper handling
of the interface by Windows.
4. ANALYZER INSTALLATION
All industry standard analyzers are supported and can be used to perform the analysis. A
comprehensive list of compatible analyzers are listed on the ProfiShark 10G product page at:
www.profitap.com
Wireshark is recommended, and can be downloaded at:
www.wireshark.org
To start capturing network data, launch the preferred network analyzer and select the new
network interface named “ProfiShark 10G Device”.
