PROEL DREAMLIGHT 1200 ECLIPSE WASH, Руководство пользователя

Страница: 43 / 52

42
DIMMER/STROBE - This function resets dimmer/strobe module.
ZOOM/FRESNEL - This function resets zoom and fresnel filter.
SPECIAL FUNCTIONS
Use this menu for special services like adjusting lamp or adjusting effects.
LAMP ADJUSTMENT - This function can be used when you make the fine
adjustment of the lamp. If you select this function the shutter will be opened and
the dimmer intensity will be set onto 100%. By using the options „Pan, Tilt, Zoom,”
you can aim the light on a flat surface (wall) and perform the fine lamp adjustment.
EFFECT ADJUSTMENT - By this function you can calibrate and adjust the effects to
their standard/right positions. Disconnect
the DMX controller from the fixture and select „DMX Values” menu. The display
shows step by step effects by which you can adjust the fixture to the required
position before the function calibration. When the positioning is finished, select
„Calibrate Values” and press [ENTER]
CALIBRATION VIA THE CONTROL BOARD
Select desired effect, press [ENTER] and adjust its right value (0 - 255). This can be
repeated for each calibred effect if it is required. When the calibration is finished, it
is necessary to use the „Save and Reset” function to write the calibration values to
the memory and to make a reset in order to check the newly adjusted positions of
the calibrated effects.
List of the calibrated effects:
Colour Wheel 1 Magenta Right Fresnel Filter
Colour Wheel 2 Yellow Left Fresnel Filter
Cyan Conversion Filter Zoom
Dimmer
LOW POWER MODE
This mode omits fixture reset after switching the fixture on and lowers motor
powers of the fixture. „Low power mode” is useful in special case e.g. if the fixture is
in a flight case and you want to set its DMX address without taking it out from the
case. To enter „Low power mode”:
Press and hold [ENTER] and at the same time switch on the Power switch. The
following message appears:
Realy Skip Initial Reset? Escape/Enter
Press [ENTER] to activate „Low power mode” without fixture reset. Now you can set
features and behaviour of the fixture by using „Fixture Address” menu and
„Personality” menu.It is expected,that this mode will be exited by switching the
fixture off, but if you want to go directly to „normal operation mode”, execute any
fixture reset.
ERROR AND INFORMATION MESSAGES
Occured errors during fixture operation are signalized by warning icon on the
display:
Press [ESC] to see the current error messages.