24
c)
Installing and locking the battery
As shown in the photos above, t
he battery has 2 thin ―slotted rails‖ (1 on each side of the battery towards the front)
and a ―raised slot‖ (towards the rear and near the handle) at the underside of the battery. These rails and slots hold
the battery in place when riding.
The battery mount attached to the bicycle has one large metal tab at the rear and 2 small metal tabs at each side.
When laying the battery onto the mount, place
the battery so the rear ―raised slot‖ near the battery handle is behind
the large metal tab on the
mount. The 2 ―slotted rails‖ on the underside of the battery should be behind the 2 small
metal tabs on the mount. The battery will now be resting flat on the mount.
Firmly slide the battery forward allowing the ends of the underside rails to fasten over the 2 small tabs (2 small tabs
lock into the ―slotted rails‖). The mount’s large metal tab at the rear must also enter the ―raised slot‖ of the battery
underside. The metal tabs will firmly hold the battery in place.
You may have to use some force when installing the battery for the first time. Once installed for the first time, it is
not as difficult to install afterwards.
Upon the battery being fully slid into place, the key will then lock the battery in place and the LED lights of the
throttle will lig
ht once the key is turned into the ―ON‖ position. If the key has difficulty locking the battery, attempt to
slide the battery in place again, following the instructions above.
To remove the battery, follow these instructions:
Locate the key ignition on the
battery base and turn the key in a counter clockwise rotation to the ―UNLOCK‖
position. You must push the key in to turn from the ―OFF‖ position to the ―UNLOCK‖ position.
Grab the handle at the back of battery and pull towards the back of the bicycle to slide it off.
The battery is now transportable and can be charged away from the bicycle.
d)
Charging the battery
The battery can be charged on or off the bicycle. If charging the battery on the bicycle, the key sh
ould be in the ―OFF‖ position.
To charge the battery, follow these instructions:
Remove the rubber cover off the battery’s RCA charging input.
Insert the charging plug from the charger into the battery’s RCA charging input.
Insert the charger’s power cord into a wall outlet.
The charger’s LED light will light RED while the charger is charging the battery.
The charger’s LED light will light GREEN upon the battery being fully charged.
The top of the battery includes a battery indicator to also check for a full charge. Press the indicator button to
display the battery’s energy storage.
Once the battery is charged, you should discontinue charging and remove the charger.
Unplug the charger’s power cord from the wall and remove the charging plug from the battery.
Lastly, cover the RCA charging input with the attached rubber cover and you are ready to install the battery
pack back onto your bicycle.
