76
>>
RECTANGULAR POOLS
>>
FIllING tHe Pool & CuttING tHe lINeR
w
Next, using a stanley knife, cut the liner inside the
flanges.
w
Mount the various fittings on the throughwall
flanges (Pool Fitting skin).
that is: 2 face plates with eyeball for the return
fittings (grease the ball with silicon grease to
facilitate its orientation)
1 vacuum plug
1 wall drain grate
w
Put the skimmer weirs in position as well as the
mouth trim enclosed in the waterproofing pack.
figure 51
figure 52
figure 54
figure 56
figure 55
caUtion
w
if while filling the
pool you note that
the liner has been
pulled out of the
track, stop filling
before reengaging
it. You may have to
partially empty the
pool before you will
be able to rehang
the liner.
w
repositioning of
the liner by sliding
it along the track
is prohibited,
this could cause
the liner to tear.
release the liner
then reposition it.
w
refer to the
additional
installation
instructions
provided with the
various fittings.
w
When the creases have been smoothed from the pool floor, continue filling the pool
until the water level is 5cm below the first pool fitting (return fitting). At this point, mark
the position of the holes in the fitting through the liner and mount the various flanges. Don’t
forget to apply the second gasket to each flange before screwing it into position.
figure 53
w
Flanges on the return fitting and vacuum point: mark the screw holes. Apply the
second seal. Screw into position (pozi countersunk head screws TFZ M5x16 from the
Pool Fitting skin). Tighten screws alternately and moderately by hand.
w
Proceed in the same way to fit the skimmer flanges.