Procentec Atlas 101-800110, Руководство пользователя

Страница: 45 / 58

© PROCENTEC
45/58
20. Resetting the device to factory defaults
If the Atlas becomes unreachable due to any reason, you can reset the device to
factory settings.
Warning: this will reset all settings, clear all measurement data and will restore
both the network interfaces to their initial IP address (Factory: 192.168.0.10;
Office: 192.168.1.10)
20.1 Using the hardware reset button
The Atlas has a reset button at the front, as shown in Figure 12. You can use a
small object, such as an unfolded paperclip, to reach the button behind the small
hole in the front. Press it for 10 seconds during operation and then release it. Do
NOT press too hard; the button requires little pressure. After 10 seconds, the device will start a factory reset
which will take approximately 2 minutes.
After the reset, it will reboot and be reachable on the default IP addresses again. You need to fill out the Setup
Wizard before the Atlas can continue normal operation again. Until that time, the yellow traffic light and the
green RDY LED will blink.
20.2 Using the Settings in the web interface
The other way to factory reset the device is through the web interface. Under the ‘Settings’ tile, go to the last
tab ‘About’. In this tab, you can find a button ‘Factory reset’. Clicking this button will bring up a confirmation
window, where you can confirm the factory reset. The device will start a reload procedure that will take
approximately 2 minutes.
After the reset, it will reboot and be reachable on the default IP addresses again. You need to fill out the Setup
Wizard before the Atlas can continue normal operation again. Until that time, the yellow traffic light and the
green RDY LED will blink.
Figure 12 - Factory reset button