Probrite STELLAR FSXD30-MS-4K-BZ, Инструкция по установке, использованию и уходу, Страница: 9 / 14

☐
The control sensor on this product will turn on the light fixture when it detects motion.
The motion sensing can be disabled for Dusk-to-Dawn operation using the built-in
photosensor that automatically turns the light fixture on during night and off during
daytime. All sensors can be disabled for manual wall switch control.
The motion sensor must be tested before setting the
time and sensitivity levels. The TEST option is located
on the TIMER control knob on the underside of the sensor
head (fig 14.). To test the fixture, switch the wall switch that
controls power to the fixture to the ON position and turn the
rotary knob to “TEST". During TEST mode, the lights will
come on for 20 seconds, regardless of motion detection or
the time of day. The light will shut off automatically after 20
seconds. Leave the rotary knob in the “TEST” position and
test the sensitivity by crossing in the path of the sensor. The
light will come on only if it senses movement. Once
movement stops, it will turn off in 5 seconds. The test is now
complete.
Setting up control sensor
☐
Adjusting motion sensitivity
The TIMER settings indicate how long the light stays on after
the control sensor detects motion. Once the fixture has
been tested for proper operation and sensitivity, rotate the
TIMER control knob clockwise to set the "stay on time" of the
motion sensor. TIMER can be adjusted up to 10 minutes ON
time. Rotating the knob counterclockwise shortens the "stay
on time" to as short as 10 seconds. It may be necessary to
adjust the TIMER knob several times until the desired ON
duration time is achieved. (fig 15)
The control knob located on the opposite side is marked
SENSITIVITY (fig 16), and determines the degree of motion
detection. Rotating this knob clockwise raises the sensitivity
of the motion sensor for up to 60 ft. of distance. Rotating the
knob counterclockwise lowers the sensitivity down to as close
as 10 ft. It may be necessary to adjust the SENSITIVITY knob
several times until the desired setting is achieved.
Step 2: Setting “STAY ON TIME” duration
after motion detection
Step 1: Testing motion activation
9 PROBRITE.COM
Please call 1-844-507-5651 or email support@probrite.com for further assistance.
OPERATION
CONTROL SENSOR OPERATING INSTRUCTIONS
NOTE: The higher sensitivity level increases the
likelihood of a false activation being triggered.
(fig 14).
(fig 15).
(fig 16).
1
2
3