PROBOIL.4E user & installation guide v1d
42
12.
Take the ¼” blue flexible pipe
(E)
that caries the cold
filtered water output from the filter and rough out the
minimum amount of pipe needed to connect to the ¼”
x ¼” pushfit connector
(F)
found on the boiler inlet.
Mark the desired minimum pipe length with a
permanent pen.
We recommend cutting the ¼” blue flexible pipe
(E)
at least 200mm longer than the required minimum
pipe length to allow the boiler to be serviced more
easily by your customer, otherwise remove
unnecessary/unneeded pipe length to keep the
installation tidy.
Cut the ¼” blue flexible pipe
(E)
to length cleanly and
squarely using a snip tool, sharp craft blade or similar.
13.
Push the ¼” blue flexible pipe
(E)
fully and firmly into
the ¼” x ¼” pushfit connector
(F)
.
14.
Firmly and fully push the silicone outlet tube
(K)
over
the 8mm barbed stem x 3/8” male tap connector
(L)
.
15.
Screw the 8mm barbed stem x 3/8” male tap connector
(L)
into the 3/8” female flexible 110°C hose tap
connector
(X5)
⚠
you must ensure to use 3/8” the fibre seal (X5)
(supplied separately with the tap) is in this
connection.
⚠
WARNING:
You must not directly connect the
tap hose (X5) directly to the boiler output (C). You
must always use output adaptor (J) and silicone
hose (K) to connect the tap.
