12
Loosen the bolts of head plate & remove the plate. Then you can attach as an under slung
mode.
Attach the Pan Tilt Head and secure by tightening the bolts. Now mount your camera with
camera mounting screw on Pan Tilt Head.
Install the 12 volt DC power (4 pin XLR) in rear of joystick box.
Note:
Any 12 volt battery may operate
the PROAIM
™
Sr. PAN TILT HEAD as long
as the connector mates and is #1 pin
Negative and #4 pin Positive.
CAUTION: DO NOT USE A UNREGULATED POWER SUPPLY! IF USING A REGULATED POWER
SUPPLY IT MUST PRODUCE LESS THAN 12 VOLTS. MORE THAN 24 VOLTS MAY CAUSE
PERMANENT DAMAGE.