Usage instructions LITTY 4all & 4you
12
If you need a greater adjustment range for the
seat heights, the
seat plate can be turned
over
. To do this, undo the M6 fixing screws at
the rotation points (AF 4 mm) completely, re-
move the seat plate and replace it turned up-
side down. Please make sure that the straight
edge remains at the front. You can see the
seat plate in the high and low position in the
following figures. Afterwards, tighten the M6
fixing screws on the rotation points (AF 4 mm)
again using 11 Nm torque.
Figure 2: Seat plate in high position, slots down
Figure 3: Seat plate in low position, slots up
To adjust the
seat depth
to suit body dimen-
sions, the distance between the
seat plate
and
back shell can be
infinitely adjusted
. The ad-
justment is made by undoing the two M6 fixing
screws (AF 4 mm) on each side in the rotation
points. The seat plate is then moved along the
slots.
Figure 4: Possible directions of movement of the
seat plate with slots
Afterwards, tighten the M6 fixing screws (AF
4 mm) on the rotation points again using
11 Nm torque.
After adjusting the seat plate, it may be neces-
sary to adjust the position of the back shell.
Please observe the instructions in Chapter
17.2.
The position of the footrest must be adjusted
whenever the seat height and angle are
changed. When doing so, ensure that there is
enough clearance under the footrest. Experi-
ence shows that this should not be less than
4 cm. You will find more details in Chapter
17.3.
17.1.2 Adjusting the LITTY 4all
Figure 5: Grid in the clothing guard with marking of
the adjustment range for the seat height, seat angle
and seat depth (grid for 22" drive wheel)
Figure 6: M6 fixing screws on the outside of the
clothing guard, to adjust the seat height, angle and
depth
Seat height, seat angle and
seat depth adjustment range
M6 fixing screws
