Usage instructions LITTY 4all & 4you
15
Notes on the back cross bar:
On the
LITTY 4you
, the back cross bar is se-
cured with the M5 fixing screws from the back
shell and its position is therefore also moved
when the back shell position is adjusted.
On the
LITTY 4all
, there are separate holes for
the back cross bar in the clothing guard (Fig.
13 and 14). Consequently, the back cross bar
here is independent of the adjustment to the
back shell position.
Figure 14: Connecting the back cross bar on the
LITTY 4all
Please note that if you move the back
shell further back, this will move the centre of
gravity further back which makes it easier to tip
the product up (Chapter 17.4).
17.3 Adjusting the lower leg length ad-
justing the footrest
The footplate arms are clamped on the left and
right into the foot bracket clamps on the lower
frame tubes. The foot bracket clamps are se-
cured against twisting through interlocking ser-
ration.
Figure 15: Illustration of terms
Figure 16: Serration on the foot bracket clamp, with
positive locking
17.3.1 Adjusting the length of the footplate
arms
To adjust the length of the footplate arms, the
M6 fixing screws (AF 5 mm) on the foot
bracket clamps have to be unscrewed. The
length of the footplate arms can then be ad-
justed.
Figure 17: M6 fixing screws on the foot bracket
clamps
17.3.2 Angle adjustment of the footplate
arms
If the angle of the footplate arms is to be
changed, then the M6 fixing screws (AF 5 mm)
need to be loosened further so that the positive
locking on the interlocking serration is re-
leased. Now the angle of the footplate arms
can be adjusted.
Once you have finished adjusting the angle
and the length, tighten the M6 fixing screws
(AF 5 mm) again using 7 Nm tightening torque.
Interlocking serration with
positive locking
M6 fixing
screws
Footplate
arm
Foot
bracket
clamps
