6
English
ASSEMBLY INSTRUCTIONS.-
Take the unit out of its box and make
sure that all of the pieces are there:
The assistance of a second person
is recommended when assembling
this unit.
Take the components out of the box
and make sure that you have all of the
pieces, Fig.1:
(1) Main frame.
(2) Support.
(3) Backrest frame.
(4) Seat tube.
(5) Seat frame.
(6) Backrest tube.
(7) Foam rod.
(8) Adjustable plate.
(9) Backrest.
(10) Seat.
(11) Foam roll.
(12) Bumper.
(13) Round plug.
(14) Square plug.
(15) Bushing.
(16) Pin.
(17) Hand grip.
(18) Screw M8x38.
(19) Screw M10x100.
(20) Screw M10x105.
(21) Screw M12x210.
(22) Washer M8.
(23) Washer M10.
(24) Washer M12.
(25) Nut M10.
(26) Nut M12.
(27) Bushing.
ASSEMBLY.-
1-
Position the front and rear supports
(2) on the front and rear main frame (1)
rests, Fig.2.
Fit the screws (20), the washers (23)
and the nuts (25) and tighten securely.
Place the plates (8) on the main frame
(1) using the screws (19), the washers
(23) and the nuts (25), Fig.2.
2-
Position the screw (21) on the shaft
of the main frame (1) holding the seat
tubes (4), (5), and the backrest tubes
(6), alternating the washers (24) as
shown in Fig.3. Place the frame (3)
between the backrest tubes (6) and
tighten the nut (26) with the screw (21)
to fix the assembly. Make sure the seat
and back tubes can rotate. Place the
pin pin (16).
3-
Position the backrest (9) and the
seat (10) on the supports (6) and (4),
(5), Fig.4 and fit the screws (18) and
the washers (22).
Fit the foam rod (7) using the screw
(19), the washers (23) and the nut (25),
Fig.4. Fit the foam rolls (11).
Do not hesitate to get touch with the
Technical Assistance Service if you
have any queries by phoning customer
services (see last page in manual).
BH RESERVES THE RIGHT TO
MODIFY THE SPECIFICATIONS OF
ITS PRODUCTS WITHOUT PRIOR
NOTICE.
