Pro-Weld AG-805, Руководство по эксплуатации и обслуживанию

Страница: 15 / 20

3 0 0 -0 8 0 5
PRO WEL D
3. Connect the black wire on the new cable (30) to
one terminal on the switch assembly (25).
4. Connect the white wire to the other terminal.
5. Connect green control cable wire to one of the
gun coil leads using wire nut.
6. Connect red control cable wire to the other gun
coil lead using a wire nut.
7. Re-install switch assembly and handle cover.
8.5 Gun Maintenance
If the gun motion becomes sluggish or erratic the
gun should be disassembled, cleaned, and lubri-
cated.
A. Disassemble the gun as described. Blow or
wipe the gun body and parts clean.
B. The inside diameters of adjustable core screw,
the lifting ring and mating diameters on the lifting
rod should be carefully examined for wear or rust.
Although the lubrication should prevent any oxida-
tion on these surfaces, if they reveal signs of dirt
or a dull reddish brown stain, clean and polish with
a fine abrasive paper, grip #0 or finer.
C. Lubricate lifting rod surface with a thin coat of
high temperature bearing grease, Lubricate M-24-
M or equivalent.
PAGE 8
4. Install front cap (4) end cap nuts (3), bellow (2),
and chuck adaptor (1). Make sure chuck adaptor is
securely tightened.
5. Guns with plunge damper, replacement damper
(33) has to be screwed all the way into the damper
cover (32). Screw damper assembly into front cap
(4)
6. Install foot and leg assembly. Adjust the plunge
and lift.
7. Replace rear cap (20) and secure with screw
(21).
8.3 Weld Cable Replacement
1. Disassemble gun as indicated in disassembly of
gun through step 4.
2. Remove handle cover screws (26) lift off handle
cover (27).
3. Pull weld cable (31) out of gun body (14).
4. Place new weld cable into gun body handle and
through cable hole in gun body.
5. Secure weld cable with screw (8) to lifting rod
assembly (6). Tighten securely.
6. Install handle cover and reassemble gun.
8.4 Control Cable Replacement
1. Remove handle cover screws (26) lift off handle
cover (27).
2. Remove wire nuts from the two wires going to
the gun coil (16). Disconnect the two wires from
the switch assembly (25) and remove control cable
(30).