In the package you will find two rolls of black UV resistant plastic wire. They are the external
insulated loop on which will take places the wires elements ends.
Find the end having the eye and install it on the bolt coming out from the boom, front side, screw
down a self-looking nut, so the eye can’t come loose. Next one, moving toward the plastic wire, you
will find a short piece of alluminum with an insulator, fit the insulator in the alluminum dipole end,
walk going at back dipole, fit the short black round insulator in the dipole end, and than go to the
boom end and insert the turnbuckle eye on the bolt end coming out from the boom pipe.
Follow the same procedure with the second one half loop. When both wires are in place, pull wires
screwing the turnbuckle. Make sure that both half loop are well balanced looking toward the boom,
it MUST be straight.
In the package there are 6 couple of steel wires elements, they are galvanized steel, protected with
black UV resistent PVC with both ends eye terminated. Unroll the wires elements, select them by
longer to shorter. Get the longer wires couple and starting from the back antenna side, connect each
one element end to his correspondent RF line, one eye to the insulator bolt, the other one end on
the corrispondet U bolt placed on the main loop insulated wire. Repeat this procedure for all
elements.
Install balun 1:2 and connect both wire end to RF line, connect the coax line taking care to run it
on the upper boom face use plastic belts or tape to hold it in place.
New Balun version
