Take out from the package the back dipole round tubes, you will get them preassembled, just pull
them out from the main pipe, following the tube tapering sequence, find the connection holes, when
they are coincident, put and screw down the bolt, make sure to have the bolt head down in the larger
hole as in the picture below. Don’t forget to lubrificate a bit the stainless steel bolts.
Screw down all nuts. Make sure that all bolt heads are aligned on the same side.
Follow the same procedure for all tube connections.
When you have both half alluminum element ready, than procede to assembly the center as in the
picture below. Make sure to have 8cm in between the line connection bolts.
Center view of back element dipole (long one)
When back element is assembled do the same procedure with front element as in the picture below
Center view of the front dipole (short one)
Boom-mast plate
