PRO-PULSE 68125139, Руководство оператора

Страница: 20 / 24

OPERATION
20
CMS174
ENGLISH
5. To begin cutting, lower the cutting head. The movable guard opens automati-
cally.
6. After cutting, allow the head to come back up. The guard will close automati-
cally.
7. The saw will stop when you release the trigger switch in the handle.
WARNING: For your safety, remove chips, small pieces, etc. from the table top
before operation.
CUTTING MODES
NOTE : at extreme positions, the hold-down clamp should be moved to the right
side of the table to prevent it interfering with the movement of the cutting head.
Always check before making the cut if there is any potential interference from the
clamp or any other part of the machine .
Compound cut:
NOTE : at extreme positions, the hold-down clamp should be moved to the right
side of the table to prevent it interfering with the movement of the cutting head.
Always check before making the cut if there is any potential interference from the
clamp or any other part of the machine .
Chop cut:
The sliding head is moved to the rear as far as possible and locked in place. The
head is locked in the upright position. The table rotation is locked at 0°.
This is a good setting for simple 90° crosscuts.
Mitre cut:
The sliding head is moved to the rear as far as possible and locked in place. The
head is locked in the upright position. To unlock the table rotation, unscrew the
locking handle (N, fig.1) and press on the mitre detent spring lever (O, fig.1 )
with your thumb Move the table rotation to the left or right up to 45° left.
The mitre detent spring lever (O, fig.1 ), if released, will stop the table at detents
at 0°, 15°, 22.5°, 30°, & 45° left and right. Use the locking handle (N, fig.1 ) to lock
the table at the desired angle, especially those between the detents. This is a
good setting for simple angle cuts.
Bevel cut:
To unlock the head angle (bevel) adjustment, loosen the bevel lock handle (D,
fig.1 ) at rear of the saw. Lock it when the blade is tilted at the desired angle. The
table rotation is locked at 0°.
The sliding head is moved to the rear as far as possible and locked in place.
Unlock and move the table rotation to the left or right as in mitre cuts above.
Using the lever at the back of the saw, unlock the head and bevel it to any
position from 0° – 45° left, then lock it in place.
This setting is for the more complex beveled angle cuts.
Sliding cut:
You can extend the cuts above to larger pieces (up to 12” - 305mm wide and 3.5”
– 90mm high on right angle cuts) by unlocking the sliding head and cutting while
sliding the head from the front to the back. When bevel cuts and mitered angles
are 45 degrees, work pieces within 45mm (1.8”) height and 210mm (8.3”) width
can be cut.
Note: at extreme positions, the hold-down clamp should be moved to the right
side of the table to prevent it interfering with the movement of the cutting head.
Always check before making the cut if there is any potential interference from the
clamp or any other part of the machine.