8510851
Variable Shade Auto-Darkening Welding Helmet
V1.3
ASSEMBLY
The welding helmet is preassembled. Remove the protective film from
both lenses before use.
ADJUST THE WELDING HELMET FIT
The headband should be adjusted both in diameter and height. The
angle between face and helmet should also be adjusted (recommended
10° to 12°).
1.
Adjust the headband diameter with the twist knob on the
headband. Twist clockwise to tighten and counterclockwise to
loosen (Fig. 1).
2.
Adjust the headband height by releasing the tab and changing
the top strap hole.
3.
Adjust the helmet position on the headband with the side tab
system. There are five pegs on the right side of the headband.
Slide the tab on the helmet over the peg on the right side to
position the welding helmet before fine tuning the viewing angle
in the next step (Fig. 2).
4.
Adjust the helmet to get the desired viewing angle. Once the
angle is correct, tighten the two angle adjustment knobs
connecting the headband to the helmet shell until snug. The
helmet should still swing up, but it should not drift downward
when in place for welding (Fig. 3).
Fig. 1
Fig. 2
Fig. 3
6
For technical questions call 1-800-665-8685