5
PRESET TIME AND TEMPERATURE
If adjustments are required, please refer to the time or temperature programming section in
this manual.
°F/°C CONVERSION
To change the temperature display from °F to °C or from °C to °F, hold the TEMP button
while the unit is turned off. While holding the TEMP button, turn the unit on. The display
will be the changed temperature mode. To change back, repeat the procedure.
OPERATING INSTRUCTIONS
. Turn unit on by placing switch in "ON" position. The "Heat On" indicator, program
number and display will flash indicating unit is heating. When the preset temperature is
reached, the heating light, display and program light indicator will stop flashing followed
by beeps. (Initial startup heating time is approximately 0 minutes).
. Place product on the bottom cooking surface of the unit and close the lids.
. Press program button and let displayed time count down to "0" at which time unit will
beep. To turn off the beeper, press program button again.
4. Raise lids until it engages into first indent and remove food. Using spatula, scrape
residue into grease catcher tray.
Note:
Metal utensils with rounded corners may be used, however, using nonmetal
utensils will prolong the life of the cooking surface.
5. Turn the unit off when not in use.
TEMPERATURE/TIMER CONTROLLER OPERATION SPECIFICATIONS
Startup:
1. The preset time will flash until preset temperature is reached.
. When the control reaches preset temperature, time display, "Heat On" indicator and
program indicator will stop flashing and the alarm will beep three times.
Temperature:
1. To view the actual temperature, press and hold "Temp Button." Display will read
"Lo F" if temperature is below 273°F (134°C) and "Hi F" if temperature is above
573°F (301°C).
