12 Fresh Water – The fresh water switch directs power to the fresh water pump. Depress the fresh water
switch to the forward position to activate the fresh water pump. Then, go to the port aft corner of the
cockpit, retrieve the fresh water faucet/nozzle and press the button on the handle. If the fresh water
system is not going to be in use, move the switch to the down position to turn the pump off.
13
14
Accessory - The accessory switches can be used for additional dealer installed accessories. Please check
the amp rating of any new component and/or additional accessory before installation. These switches are
rated for 5 amps.
Lighting Systems
Baitwell Light
The baitwell light switch is located on the switch panel and is labeled baitwell with a light symbol on the switch.
To turn on the baitwell light, press the switch forward and open the baitwell to see if the baitwell light is on. Press
the baitwell light switch to the down or aft position to turn off the light.
Cabin Light - Head
The cabin light switch provides power to the light that is located in the head. To operate the light in the head,
depress the cabin light switch on the console to the forward or on position. The light can then be turned on or off
from inside the head by depressing the small button on the base of the light assembly.
Cockpit Lights
The cockpit lights are small circular lights located at the console. Locate the 2-way
cockpit light switch on the switch panel and press the switch in the forward position to
turn on the cockpit lights. Press the cockpit light switch in the back or aft position to
turn the lights off.
Navigation and Anchor Lights
The navigation and anchor lights are required to be used for operation at night or under low visibility conditions to
indicate your position to other boaters. Visually verify the operation of your navigation and anchor lights and
check to be sure that the lights are free from obstructions. You should check your navigation lights monthly
during optimum visibility conditions.
•
When you are underway in low visibility conditions, you should have the Nav/Anc switch in the up
or forward position. This will activate the navigation lights, as well as your anchor light.
•
When you are anchored or in low visibility conditions, you should turn on the anchor light. Press
the Nav/Anc switch to the down or aft position to turn on the anchor light.
The U.S. Coast Guard requires that the anchor light
be installed at the highest point on the boat and must
be secured in the up position when you are
underway. Therefore, this light will be installed as
shown below based upon the optional top that you
may have selected:
The navigation lights consist of a pair of stainless
steel lights that are mounted at the bow of the boat.
The red light is installed on the port side and the
green light is installed on the starboard side.
•
No optional top – Light will be mounted on the console
•
Bimini top - Light will be installed on the Bimini top frame
•
Rigid T-top – Light will be mounted on the center of the Trylon top.
17
