A tripped breaker will protrude or move from its set position indicating that the circuit has been
overloaded. Turn off the device(s) on the circuit, then reset the breaker by pushing in once or by
returning a breaker switch to the on position. If the breaker does not reset or if it resets and then trips
again after the device is turned back on, then a short circuit exists or your device may be damaged,
overloaded, or faulty. Correct the problem and then reset the breaker.
If the breaker continues to trip and you are certain the device, switch and wiring are in good repair; either
the breaker is faulty or it is too small for the load. Reduce the load or replace the breaker.
Switch and Breaker Panel
The switch and breaker panel is located on the console and is equipped with 12 switches. The numbers
shown below each switch in the photo below correspond with the descriptions provided for each switch:
1 2 3 4 5 6 7 8 9 10 11 12
1 Horn - The horn is used to signal, warn, or alert other boats, swimmers or people on shore.
Depress the horn switch to the up or forward position to activate the horn. Release the horn
switch to deactivate the horn. Using different sequences of horn blasts indicates different and
sometimes dangerous situations to you or someone around you.
Avoid any horn use without an appropriate purpose. See the Safety Section in this manual and/or
take a safe boating course for more information on the proper use of the horn.
2 Aft Bilge Pump - Your 25 Walk is equipped with an aft bilge pump. This 1100 gph pump is located
in the aft bilge and the automatic float switch is mounted in close proximity to the pump.
The aft bilge pump is wired automatic to the battery and has a manual override located at the
switch panel on the console. The automatic float switch is wired directly to the
Starboard
battery
terminal through a breaker or inline fuse. The circuit breaker for the aft bilge pump is located at
the helm next to the manual switch.
Keep the bilge area clean and free from debris that could clog ports or inhibit float movement.
Also, keep the battery (starboard) that provides power to the bilge pump charged. If the battery is
not charged and flooding occurs, the boat could swamp causing damage and possible loss of life
or property.
Depressing the aft bilge pump switch to the up or forward position activates the bilge pump. If for
some reason the indicator light on your bilge pump switch comes on, check your bilge for water. It
is not uncommon for rain water or water from washing your boat to accumulate in the bilge.
Standing water will activate the automatic float that is connected to the bilge pump. If you notice
your pump running frequently during your day on the water, you should check the thru hull fittings,
hose connections, etc. for any possible leaks.
3 Navigation & Anchor/All Around Lights - Locate the Nav. Light switch on the instrument panel.
This 3-way switch (forward, middle, back/aft) functions as follows when you press the switch:
•
Forward position - Turns on the bow lights and the anchor light. This position will
also activate the red light in your compass.
17
