21
Instrumentation
Compass
The Compass on the 25 Sport is located on the dash on top of the
console. To ensure that the compass light is working properly,
press the Nav. Lts. switch in the forward position to turn on the red
LED light inside the compass. When finished, turn the Nav. Lts.
switch back to the middle position.
Please refer to the owner’s manual provided by the manufacturer of
the compass for operational procedures and for information related
to the care and maintenance of their product. When in doubt,
always defer to the compass manufacturer’s instructions and/or
recommendations.
Horn - Electric
The horn is used to signal, warn or alert other boats or persons on shore. The horn switch is located on
the switch panel. The horn device is located on the starboard side of the console.
Depress the horn switch to the up or forward position to activate the horn, then release the horn switch to
deactivate the horn. Using different sequences of horn blasts indicates different and sometimes
dangerous situations to you or someone around you.
See the Safety Section in this manual for more information. Avoid any horn use without an appropriate
purpose. Additional information regarding audible warning signals should be covered in a safe boating
course.
Full Instrumentation / Gauges
All gauges are installed on the console but the configuration and specific location of your gauges will vary
depending upon the selection of the various optional engine packages. If your engine package includes
analog gauges (i.e., Faria), the gauges will light up when the navigation lights are on. If your engine
package includes digital gauges provided by the engine manufacturer (i.e., Mercury SmartCraft, Honda,
Yamaha, etc.), the gauges will light up only when the engine is on.
Note: For boats rigged with analog gauges, the gauge configuration may include
individual gauges for the temperature, trim, volts and fuel gauges or a multifunction
gauge that includes multiple functions. For boats rigged with digital gauges, the
temperature, trim, volts and fuel gauges are incorporated into the tachometer gauge.
Tachometer
The tachometer (tach) gauges are located on the console. To ensure the tach is working properly, simply
turn the ignition key on and start the engine. While the engine is idling, the tach should be reading in the
proper RPM range recommended for the engine. Your engine manual will indicate the appropriate RPM
Spreader
Lights
Courtesy/Dome
Light
