© Pro-Ject Audio Systems · Pro-Ject Pre Box DS2 Analogue · Revision 2018.09.13
5
Technical specifications Pro-Ject Pre Box DS2 Analogue
Frequency response:
20Hz - 20kHz (-0,2/-0dB)
Noise floor:
-95dB (A weighted)
THD:
0,001%
Gain:
13dB / 19dB (13+6dB) switchable for all inputs
Pre out:
1 pair RCA/phono sockets
Output voltage typically:
1V at 1kHz (2V with +6dB gain)
Fix and subwoofer out:
RCA/phono sockets
Line-level inputs:
5 pairs RCA/phono sockets
Input impedance:
10kohms
Trigger:
12V DC switching voltage
Trigger output:
2-pole 2,5mm
co-axial jack
Outboard power supply:
18V/500mA DC, suitable for your country's mains supply
Power consumption:
220mA DC
Replacement battery remote control:
1 x CR2032 / 3V or 1 x CR2025 / 3V
Dimensions W x H x D (D with sockets): Aluminium version:
206 x 71 x 220 mm
Wood version:
240 x 72 x 220 mm
Weight:
Aluminium version:
1430 g without power supply
Wood version:
1880 g without power supply
Service
Should you encounter a problem which you are not able to alleviate or identify, please contact your dealer for
further advice. Only if the problem cannot be resolved there, the unit should be sent to the responsible
distributor in your country.
Warranty
The manufacturer accepts no responsibility for damage caused by not adhering to these instructions
for use. Modification or changes to any part of the product by unauthorized persons release the
manufacturer from any liability over and above the lawful rights of the customer.
Copyright, trademarks
Pro-Ject Audio Systems is a registered Trademark of
H. Lichtenegger.
This guide was produced by: Pro-Ject Audio Systems
Copyright
©
2017. All rights reserved.
The information was correct at the time of going to
press. The manufacturer reserves the right to make
changes to the technical specification without prior
notice as deemed necessary to uphold the ongoing
process of technical development.
