Pro-Form PFSB63131, Руководство пользователя

Страница: 14 / 24

14
Your spa features an LED light with ten different
programmed lighting effects:
1. White
2. Color Spectrum (each color is displayed for
approximately one minute)
3. Yellow
4. Blue
5. Orange
6. Green
7. Hot Pink
8. Cyan
9. Blue/Green Mix
10. Party Mode
TM (colors cycle rapidly through the
color spectrum)
The LED light is controlled with the light button on the
console. To turn the light on, press the light button. To
turn the light off, press the light button again. To select
the next lighting effect, turn the light off and then with-
in five seconds turn it on again. If the light is left off for
more than five seconds, the same lighting effect will
be displayed the next time the light is turned on.
The Temperature Buttons control the temperature set-
ting of the water. The temperature setting can be from
80°F to 104°F. The startup temperature is set at
100°F. The water heats at about 6°F per hour with the
cover on. Use a medical or other accurate thermome-
ter to check the temperature of the water.
To change the water temperature, push either the
temperature up or the temperature down button until
the desired temperature is reached. After three sec-
onds, the LCD will automatically display the last mea-
sured water temperature.
If the temperature sensors detect a drop below 40°F,
pump 1 (and the heater if necessary) will automatically
activate to provide freeze protection. The equipment
will stay on until the sensors detect that the spa tem-
perature has risen to within 15°F of the set tempera-
ture. Pump 2 and the blower will purge for 30 seconds
to 2 minutes at the end of the freeze condition.
The Blower Button turns the ten air injectors, labeled
4 in the small drawing on page 13, on and off.