10
9. Have a second person raise and hold the tread-
mill Frame (36).
Identify the Gas Spring (83). Note that the Gas
Spring has a piston end and a cylinder end.
See
the two small inset drawings.
Locate the
Spring Clip Kit (90) in the piston end of the Gas
Spring. Using your fingernail or the end of a
screwdriver, press on the end of the Spring Clip
to loosen it, rotate the Spring Clip, and then pull
the Spring Clip out of the Gas Spring.
Be care-
ful to avoid losing the Spring Clip.
Note: Extra
Spring Clips are included.
Next, hold the piston end of the Gas Spring (83)
near the bracket in the center of the Frame (36).
Press the end of the Gas Spring as far as possi-
ble onto the ball on the bracket.
See drawing 9a.
Insert the Spring Clip Kit (90)
into the two indicated small holes in the piston
end of the Gas Spring (83). Then, rotate the
Spring Clip until it clips onto the Gas Spring.
83
90
83
36
36
Bracket
Cylinder
Piston
Bracket
9a
9
90
90
Holes
90
8. Next, finger tighten four M8 x 15mm Bolts (9)
with four M8 Handrail Star Washers (11) into the
Right and Left Handrails (40, 70).
Then, tighten
all four handrail Bolts.
8
11
9
11
9
70
40
11
9
11
9
