7
5. Identify the Right Handlebar (48), which is
marked with an “R” sticker.
While a second person holds the Right
Handlebar (48) near the Upright (3), tie the pull
wire (see the inset drawing) to the right pulse
wire, and pull it into the side of the Upright and
out of the top. Then, untie and discard the pull
wire.
Slide the Right Handlebar (48) onto the Upright
(3). Attach the Right Handlebar with two M6 x
38mm Button Bolts (53), two M6 Split Washers
(43), and two M6 Locknuts (54).
Make sure that
the hexagonal holes are in the indicated
location.
Attach the Left Handlebar (47) in the same
way.
Orient the Water Bottle Holder (49) as shown.
Insert the Upper Wire Harness (32) and the left
and right pulse wires through the Water Bottle
Holder.
Then, slide the Water Bottle Holder (49) onto
the Upright (3) and attach it with an M4 x 16mm
Screw (40).
Do not tighten the Screw yet.
5
4
4. While another person holds the Upright (3) near
the Frame (1), connect the Upper Wire Harness
(32) to the Lower Wire Harness (31).
Tip: Avoid pinching the wires.
Gently pull the
upper end of the Upper Wire Harness (32) to
remove the slack, and slide the Upright (3) onto
the Frame (1).
Attach the Upright (3) with four M8 x 20mm
Button Screws (35) and four M8 Split Washers
(36).
35
35
36
36
36
32
31
36
48
54
43
53
32
49
47
Left Pulse
Wire
Right
Pulse
Wire
Hexagonal
Holes
40
3
3
1
Avoid pinching
the wires
Right
Pulse
Wire
Pull
Wire
Pull
Wire
All manuals and user guides at all-guides.com
