6
2. While another person lifts the back of the Frame (1),
attach the Rear Stabilizer (9) to the Frame with two
M10 x 75mm Carriage Bolts (34) and two M10 Nylon
Locknuts (33).
34
9
1
3
2
44
1
7
43
59
59
Make sure the
Wire Harnesses
(44, 43) do not
get pinched and
damaged during
this step.
33
3. While another person holds the Upright (2) in the posi-
tion shown, connect the Extension Wire Harness (44)
to the Wire Harness (43).
Carefully pull the upper
end of the Extension Wire Harness to remove any
slack. While holding the upper end of the
Extension Wire Harness,
slide the Upright onto the
Frame (1).
Do not pinch the Wire Harnesses.
Attach the Upright (2) to the Frame (1) with two M10 x
76mm Button Bolts (7), two M10 Split Washers (59),
and two M10 Nylon Locknuts (33).
Do not tighten the
Nylon Locknuts yet.
4. Connect the wire harness on the Handgrip Pulse
Sensor (29) to the indicated wire harness on the
Console (23). Insert both wire harnesses into the open-
ing in the bottom of the Console. Next, insert the metal
tube on the Handgrip Pulse Sensor into the opening in
the bottom of the Console.
Be careful not to pinch
the wire harnesses.
See the inset drawing. Align the holes in the bracket on
the Console (23) with the holes in the metal tube on
the Handgrip Pulse Sensor (29). Tighten two M4 x
16mm Screws (52) through the bracket into the tube as
shown.
29
23
Wire Harnesses
4
2
33
33
Tube
52
23
Bracket
29
52
Tube
5. The Console (23) requires four “D” batteries (not
included); alkaline batteries are recommended. Press
the tab on the battery cover, and lift off the battery
cover. Insert four batteries into the battery compart-
ment.
Make sure that the batteries are oriented as
shown by the diagram inside the battery compart-
ment.
Reattach the battery cover.
23
Tab
Batteries
Battery
Cover
5
