6
11
5. Whilst another person holds the Upright (2) near the
Frame (1) as shown, connect the Upper Wire (44) to
the Lower Wire (70).
Slide the Upright (2) onto the Frame (1);
be careful
not to pinch the Wires (44, 70). Attach the Upright
with two M10 x 74mm Button Bolts (27), two M10
Split Washers (59), and two M10 Nylon Locknuts (33).
Do not tighten the Button Bolts yet.
44
27
33
59
70
5
2
1
Make sure that
the wires do not
get pinched and
damaged during
this step.
6. Identify the Left Handlebar (6), which is marked with a
sticker. Insert the Left Handlebar into one of the
Handlebar Arms (5);
make sure that the Handlebar
Arm is turned so the hexagonal holes are on the
indicated side. Attach the Left Handlebar to the
Handlebar Arm with two M8 x 45mm Button Bolts
(50) and two M8 Nylon Locknuts (38).
Make sure
that the Nylon Locknuts are inside of the hexago-
nal holes. Do not fully tighten the Button Bolts
yet.
Attach the Right Handlebar to the other Handlebar
Arm (not shown) in the same way.
6
6
5
50
38
Hexagonal
Holes
Turn on the fan if desired.
To turn on the
fan at low
speed, press
the fan button.
To turn on the
fan at high
speed, press
the fan button a
second time. To
turn off the fan, press the fan button a third time.
Note: If the fan is turned on and the pedals are
not moved for about half a minute, the fan will
turn off to conserve the batteries.
Rotate the thumb wheel on the right side of the
console to pivot the fan to the desired angle.
When you are finished exercising, the console
will automatically turn off.
If the pedals are not moved for a few seconds,
the displays will pause and the time will flash in
the large display.
If the pedals are not moved and the console but-
tons are not pressed for a few minutes, the con-
sole will turn off to conserve the batteries.
6
5
Thumb
Wheel
Fan
Button
