E-11
Installation
fastener
Panel
PS-G
• Do not tighten the screws with too much force, since it can dam-
age the PS-G unit's plastic case.
• The torque necessary to create a drip-resistant seal is 0.5 N•m.
• Depending on the installation panel's thickness, etc., the number of in-
stallation fasteners used may need to be increased to provide the desired
level of moisture resistance.
• Installation fasteners are sold by your local PS-G distributor.
• Be sure to use installation fastener model GP070-AT01.
• To enhance the PS-G's maintainability, operability and ventilation,
allow at least 100 mm clearance between the PS-G and other objects.
(The clearance must be large enough to allow you to install or
uninstall option units and to attach connectors.)
• Standard installation for the PS-G unit is in a vertical panel. If the PS-
G unit is to be installed in a slanted panel, the panel should not incline
more than 30° from the vertical.
• If the PS-G panel is to be installed in a slanted panel that inclines
more than 30°, use forced-air cooling to ensure the ambient operation
temperature does not exceed 50° C.
• Horizontal installation (that is, rotating the panel so that one of its
sides is the base) is not supported.
Installation Requirements
(unit: mm[in.])
100
[3.94]
100
[3.94]
100
[3.94]
100
[3.94]
100
[3.94]
100 [3.94]
100 [3.94]
