Pro-face Pro-face ST Series, Руководство пользователя

Страница: 101 / 131

ST Series User’s Manual
7-2
7.1 RUN Mode
There are two ways of entering the ST's RUN mode; immediately after plugging in the unit's power cord, or
from the ST's OFFLINE mode.
7.1.1 After Connecting the Power Cord
The method of ST startup will vary, depending on the “START TIME” setting in the “Initialization Settings” /
“System Setup” area.
When START TIME is set to “0”
When the ST's power cord is connected, the version information screen shown below will appear. Next, the
screen designated by the initialization screen file number (“Initialization Settings” / “System Setup” area) will
appear, and the ST will start to communicate with the PLC.
When START TIME is set to any value other than “0”
In this case, when the ST's power cord is connected, the following version information screen will appear. In
the top right corner of the screen, a value will appear and count down the number of seconds designated by the
“START TIME” setting. Next, the screen designated by the initialization screen file number (“Initialization
Settings” / “System Setup” area) will appear, and the ST will start to communicate with the PLC.
If the initialization screen’s file number is not designated, or a number is designated that does not exist, the
version information screen will remain.
• There is a possibility that the screens shown above may not display in the beginning depending
on the display device’s start-up time.
Protocol Version System Version
Protocol Version
System Version
Counts down the number of
seconds designated in the
“START TIME” setting