-4-
The PL-HD220 is factory set for use as the PL's Slave drive (Second Hard Disk).
When using the PL-HD220 as the PL's Master dirve (First Hard Disk), be sure to
perform the following setup.
<PL-HD220>
Slave Setting
(for use as Slave)
Master Setting
(for use as Master)
Jumper Plug
When using the PL-HD220 as
a Master, be sure to remove
the jumper plug, as shown in
the left side figure.
• All Pro-face PL units have a built-in hard disk. This hard disk, when
shipped, is set as the PL's Master. Therefore, when an additional HDD
unit (PL-HD220) is used, be sure to set this HDD unit's jumper plug to
"Slave".
• Except for the jumper plug shown here, do NOT use any other short
plugs with the PL-HD220, since it can cause a malfunction or damage
the unit.
Hard Disk Unit Settings
2
