- 3 -
When attaching this adapter to a DIN rail, be sure to fix the cable in place so
that the cable connected is supported and does not place a weight load on the
connector. If the cable’s weight is not supported, it may eventually damage the
adapter or the DIN rail.
<Recommended Installation Method>
Be sure to install the Conversion adapter from inside the panel.
Use stud bolts 14mm [0.55in.] or longer, and secure them in place using M3 nuts. The
necessary torque is 0.5 to 0.6 N•m. The drawing shown here is with the recommended
connector and cover in place.
The size and depth of the attachment screw installation holes will vary depending on
the type of Dsub 37 pin connector used and the thickness of the panel.
Attaching the Adapter on a 35mm DIN Rail
• Attachment
Place the unit's curved, top lip over the top
of the DIN rail, and then tilt the unit down
until the bottom face attachment clip clicks
into place.
• Removal
Use a standard screwdriver to force
the unit's attachment clip down until
the bottom of the adapter is freed
from the rail. Next, tilt the adapter
up and remove.
Adapter
DIN Rail
Standard Screwdriver
Down
DIN Rail
Adapter
88±0.2[3.46±0.01]
under 4-R3
38.5±
0.2[1.52
±
0.01]
4-M3 Stud Bolt
L = 14mm [0.55in.] or longer
Use enough force when
attaching the bolts to cause
the rear of the panel to
protrude slightly.
Unit:mm[in.]
40.5 [1.59 ]
+1
0
+0.04
0
74 [2.91 ]
+1
0
+0.04
0
