- 4 -
•
If wire length is a problem, please use the NC (Not Connected) terminal for
connecting the shield (earth) wire, etc.
•
The recommended length of the wire ends is as shown below.
•
Ring terminal attachment rings should be no more than 0.8mm [0.03in.] thick.
If two ring terminals are attached to the same terminal, the combined thick-
ness will be too much and the clear plastic cover cannot be attached.
The JST company's V2-MS3 (round type) Ring terminals, or similar types are
recommended.
•
To avoid a short caused by loose ring terminals, be sure to use ring terminals
with insulating sleeve.
•
The necessary torque is 0.5 to 0.6N•m.
<Serial Interface>
•
The connector signals used in this document are based on the use of Pro-face's
optional RS-232C cable. (GP2000H-D232-3M or GP2000H-D232-10M) For
detailed signal information, please refer to the separately sold GP2000H Series
User Manual.
•
Use rough metric type M2.6 x 0.45p threads to hold the cable's set (fastening)
screws in place.
60mm[2.36in.]
