7
Solution Sequence: With the AC power supply cord unplugged, check the ring terminals for
correct polarity (Red to positive or + and Black to negative or -). Also check for corrosion free
secure connections to the batteries. Call technical support for further assistance (800.742.2740).
PROBLEM:
The LED indications change rapidly back and forth from red to green, or the
green LED will not illuminate after excessive charging time (16 hours or more).
Solution Sequence: Disconnect AC power to the charging system. On multi bank chargers,
remove the charge cable assembly of the affected bank from the battery. Take the original
charge cable assembly from this battery and attach it to the battery from which you removed the
first cable. Plug the charger in and observe the LED indications. If the rapid LED sequence (red
to green repeatedly) occurs on a different bank of the charger, this confirms that a battery
problem exists.
PROBLEM: The green (READY) LED was illuminated before disconnecting the power from
the charger, but upon reconnection, the red (CHARGING) LED appears and remains on.
Solution Sequence: This is normal operating procedure for the system and simply indicates that
a re-analysis of the battery status has been initiated and after a series of steps, the green LED
will illuminate.
PROBLEM: The indicator lights from the ProXtra II “charge on the run” system are not
illuminating while the main boat engine is running.
Solution Sequence:
Check that each charge cable ring terminal is attached securely and with proper polarity.
Check that the purple 12 Volt sense wire from the cranking battery cable assembly is installed
properly.
Check engine RPMs. The system may not operate with the engine at idle. Assure that the
system has been tested at higher engine RPMs.
For further troubleshooting, please contact technical support (800.742.2740).
PROBLEM: One or both indicator lights on the ProXtra II “charge on the run” system
remain on after the main engine is shut down.
Solution Sequence: It is normal for the “charging additional batteries” and “charging cranking
battery” lights to remain on for a brief period of time following main engine shutdown. As the
battery voltages decrease, the lights will extinguish.
If one or both lights remain on indefinitely, please contact technical support (800.742.2740).
POST-INSTALLATION TESTING
After completing the total installation process for your Xtreme system, it is possible to test the
ProXtra II section of the system for proper operation without having to operate the main engine.
Attach a battery charger designed for a 12 Volt system to the cranking battery.
Turn the ignition key switch to the ON position.
Turn the charger on and observe the indicator lights on the ProXtra II section of the Xtreme.
When the voltage of the cranking battery reaches a predetermined level, the “charging cranking
Содержание Dual Pro SE XTREME
Страница 9: ...9...
