5
The five red LEDs enable you to track the progress of the charge cycle on each battery as the
voltage rises. Indications are as follows:
“Charging on the run” Indications
During periods in which the engine starting battery is being charged and maintained by the
engine driven charging system, amber and red LED indicators are provided that display the state
of the integrated ProXtra circuitry, which controls the flow of the current to additional batteries.
Indications are as follows:
CHARGING CRANKING BATTERY: This amber LED is illuminated whenever the voltage of the
engine starting battery is in excess of 13.0 Volts.
CHARGING ADDITIONAL BATTERIES: This red LED is illuminated during periods when the
Proxtra circuitry is allowing charging current to flow to additional batteries.
INSTALLATION INSTRUCTIONS
All PCS battery charging systems are designed to be permanently installed in a well-ventilated
area and have no mounting restrictions.
Do not make any electrical connections to the power supply (AC) or to a battery (DC) until the
installation process has been completed.
If mounting the charger in a boat, please choose a flat surface as high above the water level as
possible. If a compartment wall is chosen, make certain its strength is adequate to support the
weight of the charger.
Use the mounting flanges of the charger to mark locations for starter holes. Drill a 1/16 inch hole
at each marked location. Then, utilize all the stainless steel screws that have been provided and
install the charger securely, being cautious not to over tighten the screws. Silicon sealer should
be used to secure and waterproof the screw holes.
Содержание Dual Pro SE XTREME
Страница 9: ...9...
