4
support when service or repair is required (
615.471.5300
). Incorrect reassembly may result in risk of electrical shock or
fire.
13.
Check for damaged parts.
Before using any battery charger, carefully check any part that appears damaged to
determine that it will operate properly and perform its intended function. Check for broken parts and any other condition that
may affect proper operation. Any part that is damaged should be properly repaired or replaced by a qualified technician. Do
not use the charger if any part does not operate properly.
14.
Replacement parts and accessories.
When maintaining, only use accessories intended for use with this charger.
Approved accessories are available from Pro Charging Systems (
615.471.5300
).
SAVE THESE INSTRUCTIONS!
INSTALLATION AND PREPARATION
To reduce risk of battery explosion, follow these instructions, those published by the battery
manufacturer, and by the manufacturer of any equipment that you intend to use in the vicinity of
battery. Review all cautionary markings on these products and on the engine.
Pour réduire le risque d’explosion, lire ces instructions et celles qui figurent sur la batterie.
If it is necessary to relocate the battery for charging, first remove the grounded terminal from the battery. Then make
sure all accessories are off, so as not to cause battery arcing.
RISK OF EXPLOSIVE GASES: WORKING IN THE VICINITY OF A LEAD-ACID BATTERY IS
DANGEROUS. Batteries generate explosive gases during normal battery operation. For this reason, it is of utmost
importance that prior to each use of your charger, you read this manual and follow the instructions exactly.
Il est dangereux de travailler a proximité d’une batterie au plomb. Les batteries produisent des gaz explosifs en service normal. Il
est aussi important de toujours relire les instructions avant d’utiliser le chargeur et de les suivre à la lettre.
Do not operate charger in a closed-in area or restrict ventilation in any way.
Ne pas faire fonctionner le chargeur dans un espace close et/ou ne pas gener la ventilation.
Clean battery terminals. Be careful to keep corrosion from coming into contact with eyes.
Add distilled water to each cell until battery acid reaches level specified by battery manufacturer. This helps purge excessive
gas from cells. Do not overfill. For a battery without cell caps, carefully follow manufacturer’s recharging instructions.
Study all battery manufacturers’ specific precautions such as removing or not removing cell caps while charging and
recommended rates of charge.
When using an extension cord, make sure:
• that pins on plug of extension cord are the same number, size, and shape as those of the charger’s plug;
• that
extension cord meets UL (Underwriters Laboratories, Inc.) acceptance;
• that wire size is large enough for AC ampere rating of charger.
Always make your extension cord connection on the charger side before connecting to a nearby
230VAC GFCI protected (Ground Fault Circuit Interrupt) outlet. Failure to use a GFCI outlet may
result in electrical shock.
