P
P
r
r
o
o
-
-
B
B
e
e
l
l
L
L
t
t
d
d
T
T
e
e
c
c
h
h
n
n
i
i
c
c
a
a
l
l
m
m
a
a
n
n
u
u
a
a
l
l
H
H
U
U
-
-
F
F
r
r
e
e
e
e
w
w
a
a
y
y
R
R
a
a
n
n
g
g
e
e
S
S
y
y
s
s
t
t
e
e
m
m
U
U
s
s
e
e
r
r
G
G
u
u
i
i
d
d
e
e
7
7
9
9
A salvo will override any restrictions in a panels list of controllable destinations.
Route inhibits are obeyed.
Salvo takes do not override protected routes.
These panels can be defined, via the editors, to work in Panel swap mode. When a
take button is pressed the previously routed sources are exchanged with the pre-
selected source association. The Preset display will be updated to show the
previously routed sources (on active levels only).
Any four of the following functions; <LINE-UP>, <ALT-DEST>, <DEST-IDENT>,
<PROTECT>, <INCREMENT>, <DECREMENT>, <CONFIG-AUD> and <DISPLAY-AUD> can
be assigned to the four special function buttons on this panel type.
<PROTECT>, <INCREMENT> and <DECREMENT> can also be assigned to the keypad
buttons.
<CLEAR> is dedicated to the bottom right button of the keypad.
<PROTECT> does not require an LED button. Setting a destination protected is
described below:
1
Press <PROTECT>. ‘PROTECT?’ will flash in PRESET display to indicate
destination will be protected on a TAKE.
2
Press <TAKE>. The destination is protected. PRESET display reverts to
showing what was displayed previously.
The protect lamp (situated to the left of the DESTINATION display) indications are
described below:
A protect lamp ON indicates that the most significant active controllable level in the
selected destination association is protected from this panel.
A protect lamp ON for a period of 5 seconds, after a take, indicates that at least one
active controllable level in the selected destination association is protected.
A protect lamp OFF indicates that the most significant active controllable level in the
selected destination association is unprotected.
A protect lamp FLASHing indicates that the most significant active controllable level
in the selected destination association is protected from another panel.
If a valid destination association is configured, the ‘STATUS’ display shows the source
routed for the most significant active level and the ‘DESTINATION’ display shows the
destination association name for the assigned destination association.
