Prism Medical UK Transactive Xtra, Руководство пользователя

Страница: 17 / 40

Transactive Xtra User Manual Page 17 of 40 Part No. 999015 / Rev.2 / Nov 2017
Moving the H-System traversing beam (continued…)
This can be accomplished in one of two ways.
If the installed H - traversing beam is manually traversing then the
beam is moved along the support tracks by manually moving the
beam, hoist, and individual in one motion.
This movement is the same as that used for a manual traversing
hoist, as previously described.
If the installed H - System traversing beam is a motorised
traversing, then the beam is moved along the support tracks by
pressing either the black or white
hand control button.
See (fig 7b.) on the previous page.
This will move the beam in the
direction of travel as noted by the
black and white arrows located on the
underside of the hoist. See (fig 7c.)
Directional arrows on underside of power traverse H - System
hoist. Black and white arrows show traversing beam direction of
travel when the corresponding coloured button is pressed on the
hand control.
Always use extreme care when moving the traversing beam. Watch out
for and avoid any obstructions that may cause injury to the individual in
the sling, or damage to the hoist / track.
8.5 Return to charge
If your motorised, traversing hoist has a return-to-charge feature
(RTC), pressing & holding the blue and yellow coloured directional
hand control buttons simultaneously for 3-5 seconds (to produce
beeping noise) will automatically retract the hoist’s carry bar and
drive the lift along its track until
it docks at the charger.
Note that the RTC feature has
several characteristics that may
be altered to the user’s
preference. This will be set
during installation.
(fig 7c.)