Priorit EBEL:VENT EN-U, Руководство по эксплуатации

Страница: 21 / 62

Errors
21
charcoal filter can then be removed. The new filters must be inserted in the correct order, i.e.,
activated charcoal filter at the bottom/particle filter at the top. This ensures that the particle filter lies
upstream of the activated charcoal filter in the airflow and keeps dust from covering the activated
charcoal filter. The cover can then be replaced onto the housing and the toggle-type fasteners can be
closed again. Finally, the power supply can be reconnected.
3 Errors
Error Cause Troubleshooting
Device not working No voltage Check mains voltage
Defective device Send in device
Red volume flow light Defective blower Send in device
The device shows a saturation
error immediately after the
heating phase Outgassing of materials from
the interior Disconnect the mains plug,
open the cover, remove the
filters and ventilate for several
minutes. Re-insert the filters in
the correct order, close the
cover and restart the device
The red warning light for filter
saturation is on and the airflow
has been interrupted Activated charcoal filter is
saturated Replace filter
4 Technical Specifications
Volume flow approx. 30 m³/h
Monitoring - blower function
- saturation of activated charcoal filter
LED display RED / error
– GREEN / RUNNING
Signal output floating output for blower function and saturation
Voltage 230 V / 50 Hz
Current consumption As 0,15 A
Motor protection against voltage reversal; electrical blocking and overload
protection
Switching capacity
– floating
outputs
max. 230V / max. 5A
Weight 15 kg
Allowable storage temperature -20 °C to +60 °C
Allowable operating temperature 0 °C to +40 °C