PrintDry FD2003-120, Инструкция по эксплуатации, Страница: 8 / 16

- 8 -

Feed + Dry Function
1 Follow steps 1 and 2 in the previous section.
2 Pass the filament through the holes in the plastic trays and feed it into your
3D printer, it is very important to adjust the dryer’s position for a smooth
feeding.
3 Follow steps 3-6 in the previous section.
RECOMMENDED DRYING TIME
No. Filaments
Dryer
Temperature
Drying Time
(Hours)
1
PLA 55°C (131°F) > 3
2
ABS 65°C (149°F) > 3
3
PETG
65°C (149°F) > 3
4
Nylon 75°C (167°F) > 12
5 Desiccants 65°C (149°F) > 3
6
PVA 45°C (113°F) > 10
7
TPU/TPE 55°C (131°F) > 4
8
ASA 65°C (149°F) > 4
9 PP 55°C (131°F) > 6
10
HIPS 65°C (149°F) > 4
11 PC 75°C (167°F) > 6
12 PEEK 75°C (167°F) > 6
These recommendations are made under the following conditions.
*Ambient RH:50% *Ambient Temp:25°C *500g filament spool * Original filament
Actual filament drying time varies due to filament additives, initial water content level
and ambient temperature & humidity. If a filament has been exposed in the air for
weeks, very likely a lot of moisture has been absorbed and much longer drying time
(double the regular drying time) is needed. In addition to drying the filament prior to
3D printing, drying the filament while printing is always recommended.