PrintDry FD2003-120, Инструкция по эксплуатации, Страница: 2 / 16

- 2 -
When using an electrical device, basic safety precautions should always be followed,
including the following:

Read all instructions before using the Tiertime filament dryer (hereinafter
referred as the "dryer").

Always use a heat resistant surface.

DO NOT touch hot surfaces.

To protect against electrical hazards, DO NOT immerse cord, plug or the dryer
in water or any other liquid. DO NOT switch the dryer ON if surfaces are wet.

Do not allow children to use the dryer, close supervision is necessary when the
dryer is used near children.

Unplug from outlet when not in use and before cleaning. Allow to cool before
putting on or taking off parts.

DO NOT operate the dryer with a damaged cord or plug or after the dryer
malfunctions, or has been damaged in any manner. Return the dryer to the
manufacturer for examination, repair or adjustment. See Warranty section.

The use of accessories/attachments not recommended may cause hazards.

DO NOT use outdoors.

DO NOT let cord hang over edge of table or counter, or touch hot surfaces.

DO NOT
place on or near a hot gas or electric burner, or in a heated oven.

DO NOT block the air intakes or exhaust in any manner.

DO NOT use for other purposes other than the intended use.

To disconnect, turn the power switch to ‘OFF’, then unplug from wall outlet.

DO NOT pour liquids into the dryer.

DO NOT
leave the dryer unattended while in use.

DO NOT operate near combustible or pressurized spray cans.

DO NOT use the dryer more than 48 continuous working hours. After a
maximum of 48 hours in use, turn OFF the dryer, unplug and allow it to cool.

Leave a minimum 30 mm (1.25") open space all around the exterior of dryer.

The use of unauthorized accessories may cause injuries.

Store in a dry & clean place. Do not drop, knock or shake the dryer. Rough
1. IMPORTANT SAFEGUARDS